Technical Features; Accessories On Request - Eurosystems La Zappa Mode D'emploi

! ! ! ! !
TILLER : HOW TO START
- Insert the plug into the socket 230 volt,
- Make the wire to pass into the wire-holder (13) then into the rod (10) in order to make it away from the rotating tines (fig. 2).
- Press the yellow switch (1) and pull the lever (2) (fig. 5).
- Once the engine is switched on , let the switch to go (1) making the lever to be still pressed (2) N.B. the electric engine is not showing , at the
beginnng , the same torque of a piston engine , so it is necessary to make the rotavator to be up from the ground making the spur to play ( fig.
1 part 46) . When you get to the tools max rotation speed it is possibile to start working , making the rotavator to touch the ground.
- As far as concerns the unit switching off and the rotavators stopping, slacken the yellow lever (fig. 5 part. 2).
- In the internal part of the switch (fig. 4) there is an internal device which , in case of overload , it stops the electric power supply to the engine
In case it happens , wait for some minutes and re-start with switching –on operations . It is important to eliminate the overload problem which
can be due to the tiller over-use or to any other problems during the ordinary functioning.
! ! ! ! !
HOW TO DISASSEMBLY ROTAVATORS
Use the center-punch from the accessories envelope in order to take the pin away fig. 1 part. 56 and to disassembly the rotavators. Clean and
slightly grease the shaft before to go on assemblying a new rotavator or another accessories.
! ! ! ! !
HOW TO MAINTAIN – CHANGE OIL
Generally speaking oil should be changed every 60 hours working ( viscosità oil sae 80) . Go on as follows : loosen the screw-cap. (fig. 1 part.
59) and put the unit in on an inclined position and make the oil to flow out . Put in the unit some fresh oil for a quantity about 0,25 lt. In order to
verify oil level put the machine in a horizontal position , unscrew the cap (fig. 1 part. 59) and check the oil to be a little bit less than the hole lower
level . The filling/emptying corresponds to the oil level.
! ! ! ! !

TECHNICAL FEATURES

Transmission : from motor pulley to worm screw by belt; worm-screw-helical gear (in oil-bath) for transmission to drive shaft. Cultivator: with hoes,
working width 36cm., complete with safety case Max tiller speed: 120 RPM. Safety device: all cultivators are equipped with a safety device which
disengages the transmission automatically when the corresponding control lever is released.
! ! ! ! !

ACCESSORIES ON REQUEST

Rotavators cm. 16: it is easy to use it for an easier hoeing on narrow rows - De-thatcher: it is good to eliminate the grass entanglement and musk
from fields and gardens – Aerator: it is a good tool for your own garden care as the blades can make little furrows into the ground and aereate
it - Ridging plough: it is necessary to use it to cut small furrows before sowing.
The rotavators, de-thatcher, aerator and ridging plough can be assembled on the rotavators-holder shaft with screw M8 and nut , after having
disassembled the standard pin ( cm. 36) . The ridging-plough , on the contrary can be assembled to the machine instead of the spur and can be
fixed with a "r" pin. It is absolutely forbidden to use tools/equipment other than the above described ones. Pay attention to the tools rotating
direction.
6