Denon AVR-1404/484 Mode D'emploi page 36

ENGLISH
6
(Remote control unit)
(Remote control unit)
7
(Remote control unit)
(Remote control unit)
8
(Remote control unit)
(Remote control unit)
NOTE:
• When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the
setting will be completed.
Surround parameters w
CINEMA EQ. (Cinema Equalizer):
The Cinema EQ function gently decreases the level of the extreme high frequencies, compensating for overly-bright sounding motion picture
soundtracks. Select this function if the sound from the front speakers is too bright.
This function only works in the Dolby Pro Logic, Dolby Digital and DTS Surround modes. (The same contents are set for all operating modes.)
D.COMP. (Dynamic Range Compression):
Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud sounds). For listening late at night,
or whenever the maximum sound level is lower than usual, the Dynamic Range Compression allows you to hear all of the sounds in the
soundtrack (but with reduced dynamic range). (This only works when playing program sources recorded in Dolby Digital.) Select one of the four
parameters ("OFF", "LOW", "MID" (middle) or "HIGH" (high)). Set to OFF for normal listening.
LFE (Low Frequency Effect):
Program source and adjustment range
1. Dolby Digital: –10 dB to 0 dB
2. DTS Surround: –10 dB to 0 dB
When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct Dolby Digital
playback.
When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback.
When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to -10 dB for correct DTS playback.
36
Use the (left) and (right) buttons to set the D. COMP.
D.COMP.
Press the SURROUND PARAMETER or
NOTE:
This parameter is not displayed during DTS playback.
Use the (left) and (right) buttons to set the LFE level.
LFE
• The level can be adjusted in units of 1 dB from –10 to 0 dB.
Set to the desired level according to the speaker systems being used and the source to be played.
Press the SURROUND PARAMETER or
To reset the settings to the factory defaults, use the
DEFAULT
Press the SURROUND PARAMETER or
(Initial)
OFF LOW
OFF
(left) button
(down) button to switch to the LFE setting.
-10dB
0dB
(left) button
(down) button to switch to the default setting.
(left) and
YES
Y/N
(left) button
(down) button to switch to the CINEMA EQ. setting.
MID HIGH
(right) button
(Initial)
-5dB 0dB
(right) button
(right) buttons to display "Yes".
Y/N NO
(right) button