Maintenance Instructions; Moving And Storage Instructions - Schumacher Electric SJ1332 Manuel D'utilisation

total wattage used by the device being
powered by the converter.
5. Turn the device on.
6. If the device does not operate properly
when first connected to the converter,
push the converter rocker switch ON,
OFF, and ON again in quick succession.
If this procedure is not successful, it is
likely that the converter does not have
the required capacity to operate the
device intended.
7. Charge the unit as soon as possible
after each use.

6. MAINTENANCE INSTRUCTIONS

6.1 After use and before performing
maintenance, unplug and disconnect
the jump starter.
6.2 Use a dry cloth to wipe all battery corrosion
and other dirt or oil from the battery clips,
cords and the jump starter case.

7. MOVING AND STORAGE INSTRUCTIONS

7.1 Store inside, in a cool, dry place.
7.2 Do not store the clips on the handle,
clipped together, on or around metal, or
clipped to cables. The clips on the jump
starter are live when the switch is in the
ON position and will produce arcing or
sparking if they come in contact with each
other. To prevent accidental arcing, always
place the switch in the OFF position and
keep the clips on the storage holders when
not using it to jump start a vehicle.
7.3 If the jump starter is moved around the
shop or transported to another location,
take care to avoid/prevent damage to the
cords, clips and jump starter. Failure to
do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store the
jump starter in or on any area or surface
8. TROUBLESHOOTING
PROBLEM
The unit won't jump
start my car.
POSSIBLE CAUSE
Jump Start/USB switch is not
turned ON.
Clips are not making a good
connection to the battery.
The internal battery is not charged.
The vehicle's battery is defective.
RISK OF ELECTRIC SHOCK.
Incorrect operation of your converter may
result in damage and personal injury.
The converter output is 120V AC and can
shock or electrocute the same as any
ordinary household AC wall outlet.
NOTE: The maximum continuous load is
200 watts. Do not use the converter with a
product that draws more than 200 watts,
as this may cause damage to the converter
and the product.
6.3 Ensure that all of the jump starter
components are in place and in good
working condition.
6.4 All servicing should be performed by
qualified service personnel.
where damage could occur if the internal
battery should unexpectedly leak acid.
7.4 IMPORTANT:
• CHARGE IMMEDIATELY AFTER
PURCHASE
• KEEP FULLY CHARGED
Charge the jump starter's internal battery
immediately after purchase, after every
use and every 30 days.
All batteries are affected by temperature. The
ideal storage temperature is at 70°F. The
internal battery will gradually self-discharge
(lose power) over time, especially in warm
environments. Leaving the battery in a
discharged state may result in permanent
battery damage. To ensure satisfactory
performance and avoid permanent damage,
charge the internal battery every month.
Turn ON the Jump Start/USB
Switch.
Check for poor connection to
battery and frame. Make sure
connection points are clean. Rock
clamps back and forth for a better
connection.
Check the battery charge status
by pressing the button on the front
of the unit. See Checking the Level
of the Internal Battery.
Have the battery checked.
• 7 •
SOLUTION