Maintenance Instructions; Storage Instructions; Troubleshooting - Schumacher Electric 715005062 Manuel D'utilisation

3. When finished using the LED light, press and hold the
the light turns off.
4. Recharge the unit as soon as possible after each use.

8. MAINTENANCE INSTRUCTIONS

8.1 After use and before performing maintenance, unplug and disconnect
the unit.
8.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from
the battery clamps, cords, and the outer case.
8.3 Do not open the unit, as there are no user-serviceable parts.

9. STORAGE INSTRUCTIONS

9.1 Charge battery to full capacity before storage.
9.2 Store this unit at temperatures between - 4°F- + 140°F ( - 20°C- + 60°C).
9.3 Never completely discharge the battery.
9.4 Charge after each use.
9.5 Charge at least once every month, if not in frequent use, to prevent
over-discharge.

10. TROUBLESHOOTING

Jump Starter
PROBLEM
The jump starter turns on, but
won't jump start my vehicle.
The jump starter will not
recharge.
All four LEDs flash.
The last LED flashes, then
turns off.
When cable is connected only
to the battery: Solid Red LED,
(Green LED off); beeps once
per second
When cable is correctly
connected to both battery
and jump starter: Green LED
blinking; Red LED off; no beep.
REASON/SOLUTION
Make sure the unit is charged.
Verify the charge level of the jump starter is
at least 50%.
Do not attempt to jump start your vehicle
more than three consecutive times. If
the vehicle still does not start, consult a
qualified service technician.
Make sure the power source is live.
Low or high temperature. LEDs will stop
flashing when the condition is corrected.
Over-discharge. Recharge the internal
battery.
The vehicle battery voltage is lower than
10.5V. User can connect to jump starter
and turn key to jump start the vehicle.
"Fake" high battery voltage is detected,
but reverse charging protection did not
activate. User can turn key to jump start
the vehicle.
• 10 •
button until
487802782