Installation Options - Hach FP 360 sc Manuel D'utilisation De Base

remove the protective cap on the controller socket and keep it to
4.
seal the connector opening in case the sensor must be removed.
Connect the sensor to the controller using the keyed quick-connect
5.
fitting. Hand-tighten (refer to
Note: Connector cables are available in various lengths. Maximum
overall cable length is 40 m (131,23 ft).
Figure 4 Connect the sensor to the controller
Figure 4).

Installation options

The sensor may need to be installed with additional optional accessories
depending on the area of application.
Note: Refer to the documentation supplied with the accessories for
detailed installation instructions.
Installation with the chain mount kit
The FP 360 sc sensor is installed with the chain mount kit in open
channels, shafts and tanks.
Figure 5 FP 360 sc measurement sensor with chain mount kit
Sensor without cleaning unit
1
Sensor with cleaning unit
2
English 9