Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL ETH 2000 Instructions D'origine

6. Operation
6.1 Topple cut-out
If the appliance topples during operation it will be
turned off . After the equipment is stood upright
again, it will restart immediately.
Note: The topple cut-out makes a noise that can
be heard if the equipment topples. This is not a
fault.
6.2 Heat output switches / Thermostat control
(Fig. 2):
•
Off setting (Item A)
•
Fan setting (Item B)
•
Low heating output (pos. C)
•
Maximum heating output (Item D)
Turn the control to "E" until the required room tem-
perature has been reached. Then turn the control
in the direction of "F" until you hear a clear click.
The thermostat control will switch the radiator on
and off automatically to maintain the room tem-
perature at an almost constant level. However,
this presupposes that the radiator has suffi cient
output to cover the heating requirements for the
room.
6.3 Overheating guard
In case of excessive heating the equipment will
shut down automatically. If this occurs, turn off the
equipment, disconnect the mains plug and wait
a few minutes for the equipment to cool. After eli-
minating the cause (e.g. a covered air grille), the
equipment can be switched on again.
If the overheating guard triggers repeatedly,
please contact your customer service center (in
Germany ISC GmbH).
7. Cleaning, maintenance and
ordering of spare parts
7.1 Cleaning
•
Before carrying out any cleaning and main-
tenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
•
Use a damp cloth to clean the casing.
•
Remove dust pollution with a vacuum cleaner.
Anl_ETH_2000_SPK7.indb 12 Anl_ETH_2000_SPK7.indb 12
GB
7.2 Servicing
•
Maintenance and repair work may only be
carried out by an electrical servicing contrac-
tor or ISC GmbH.
•
Check the mains lead at regular intervals
for signs of defects or damage. A damaged
mains lead may only be replaced by an elec-
trician or ISC GmbH in compliance with the
relevant regulations.
•
There are no parts inside the equipment
which require additional maintenance.
7.3 Ordering spare parts
Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 12 -
17.02.2017 07:53:51 17.02.2017 07:53:51