Programming The Run Times; Deleting The Run Times - Becker Centronic VarioControl VC320 Notice De Montage Et D'utilisation

Programming the run times

Programming of the run times is only possible with transmit-
ters which support the function "MemoControl".
Each radio receiver can save one switching time for one UP and one DOWN
cycle.
In the " " slide switch position, this shading solution action is repeated every
24 hours.
It does not matter what position the
the switching time. Any stored switching times are overwritten.
1. Run the shading solution to the opposite limit position if necessary.
2. Wait until the time at which the automatic run command is to be carried
out.
3. At the desired time, press and hold the relevant direction button until the
drive briefly stops after approx. 6 seconds and then continues to the limit
position.
4. You can now release the direction button.
The receiver has saved the current time for this direction of travel.
When deleting, both run times are always deleted.
To delete the UP and DOWN run time, press the STOP button for 10 seconds.
The shading solution shifts to confirm.
The run times are now deleted.
28 - en
/ slide switch is in when programming

Deleting the run times