Opening And Closing The Housing - Ingeteam INGECON SUN 3Play Série Manuel D'installation

Ingeteam Installing the unit

6.3. Opening and closing the housing

To access the inside of the unit, remove the front screws highlighted in gray in the following figure and open the
cover as shown below.
After making the different connections explained in the sections below, close the unit before starting it. To close
the housing, tighten the aforementioned screws applying a torque of 6 Nm.
Check that the unit is correctly closed before starting up the unit.
INFO
Section "2.7. Description of cable inlets" indicates the range of cable diameters valid for each cable grommet.
84 ABO2011IQM01_C - Installation and Operation Manual