General Instructions For The Installer; General Notes - Esse-ti FlyView Manuel D'installation Et Utilisation

GENERAL INSTRUCTIONS FOR THE
G N
ENERAL
•
Carefully read the notes contained in this section as they provide important
information on the correct safe installation, use and maintenance of the
product.
•
The product must be EXCLUSIVELY used for the purpose it was designed
for. Esse-ti shall not be responsible for damages arising from improper use.
•
The product has been designed in compliance with the regulations in force
and must be installed in system that comply with the provisions of law.
•
Before connecting the product to the electric mains, make sure that the line
voltage corresponds to the value indicated on the product label.
•
Always disconnect the product from the power supply mains before
carrying out any operation either inside or outside the product (cleaning,
maintenance, etc.).
•
A protective cut-out switch must be installed upstream in order to interrupt
power supply in case of fault.
•
Always refer to an authorised assistance centre for repair.
•
Install the product in a well-ventilated place, making sure not to obstruct
the ventilation slots.
•
Beware of symbols showing lightening with arrow inside a triangle since
they indicate the presence of dangerous voltage.
•
Beware of symbols showing an exclamation mark inside a triangle since
they indicate potentially dangerous or even lethal situations that require
utmost attention.
•
For information on how to use the product see the paragraph "Technical
Features".
•
Do not use the product in association with other electric or electronic
devices that were not especially designed to be used with it.
•
Do not install the product in potentially explosive environments.
•
Make sure that the product has been installed as required.

GENERAL INSTRUCTIONS FOR THE INSTALLER

INSTALLER
OTES
65