Preparing The Appliance; Setting The Time; Preparing Coffee - SEVERIN KA4813 Mode D'emploi

4 Preparing the appliance

1. Remove all protective films and other packaging material from
the appliance.
2. Set up the appliance in a place that fulfils the following conditions:
• Near a socket outlet with earthing contact (fuse at least 10 A)
• Horizontal and free from vibration/shocks
• Heat-resistant
• Does not react to rubber pads
• Away from heated or flammable surfaces and objects (> 1 m)
• Away from walls (> 15 cm)
3. Clean the appliance as described under ►"7.2 Daily cleaning" on page
30.
4. Run water through the appliance as described under ►"7.3 Running
water through the appliance" on page 31.
Turn off button sounds
TIP
A beep is emitted to confirm each button press.
These button sounds can be switched off. The
beeps emitted after the brewing/warming processes
cannot be disabled!
1. Press the " " button for 2 seconds. You will see "
flashing on the display.
2. Press the " " button
→ : button sounds switched on
→ : button sounds switched off
→ Wait a few seconds. The most recent option displayed will be
applied.

Setting the time

1. Repeatedly press the "
2. Repeatedly press the "
 The time is now set.
Set switch-off time
1. Press the "
display.
2. Press the "
→ Wait a few seconds. The most recent option displayed will be applied
and the switch-off time has been set.
" and " "

5 Preparing coffee

TIP
You must first set the time to ensure the program-
ming function works correctly. If you do not wish to
use this function you can skip setting the time.
" button to set the hour.
" button to set the minutes.
TIP
The hotplate will remain on for 35 minutes (factory
default) after the coffee is prepared. At the end
of the heating process you will hear three beeps.
The switch-off time can be configured as follows:
0/15/35/45/60 minutes.
" button for 2 seconds. You will see 35 flashing on the
" button repeatedly to set the desired switch-off time.
WARNING!
Risk of scalding!
– Do not place parts of the body under the drip
stop while the appliance is in operation.
GB
25