Adjusting The Beverage Quantity; Co Ee Pads - SEVERIN Fino Multi KA4566 Mode D'emploi

Fino Multi KA4566

3.2 Co ee pads

C
10

Adjusting the beverage quantity

The beverage quantity for lter co ee can be adjusted and saved in 5
interval steps (also see table in section „3.4 Beverage quantity, brewing
temperature and steep time – overview").
1. Insert the strainer support for lter co ee into the appliance as
described above.
2. Press and hold the Start/Stop button (H.5)
elements (H.1) and (H.4)
3. Through repeated short pressing of the Start/Stop button (H.5)
can increase the beverage quantity by one interval step, respectively. If
the maximum beverage quantity has been reached and you press the
button again, setting starts again with the rst interval step.
4. When you have reached the desired setting, press and hold the Start/
Stop button (H.5)
extinguish. Now the setting is saved.
Note: If no button is pressed within 30 seconds, the settings are not
!
changed and the programme returns to stand-by mode.
1. Place a co ee pad into the centre of strainer support (C).
Note: Only use commercially available round soft co ee pads. If the co ee
!
pad is slightly bulged on one side, place the pad into the strainer support
with the bulged side facing downwards. Never ll co ee powder into the
strainer support for co ee pads.
2. Now open brewing unit (A). For this purpose, fully fold open the
bracket closure (B) and insert the strainer support. When inserting the
components into the brewing unit (A), make sure the paper edge of the
co ee pad is not placed below the gasket.
3. Close the brewing unit (A) by rmly pressing the bracket closure (B)
downwards.
4. Place a suitable co ee cup onto the drainage grille (G).
5. Press the Start/Stop button (H.5)
(cup symbol ashing (H.1)
is lled with co ee. Progress is displayed by means of the interval
indication .
6. Please wait until your appliance has completed the follow-up time, i.e.
the display element (H.1)
generated.
light up.
until the display elements (H.1)
. The brewing process is started
). After a short heat-up phase the cup
stops ashing. A short acoustic signal is
until the display
you
and (H.4)