SEVERIN Fino Multi KA4566 Mode D'emploi page 45

Fault
The brewing unit cannot be
closed.
The display element
beverage quantity / brewing
process ashes quickly
during the brewing phase.
The beverage quantity is too
high or too low.
Tea is too cold or too hot.
You feel the steep time for
tea is too short or too long.
After the heat-up phase (cup
is ashing) the appliance
switches o without
performing the brewing
process.
The heat-up phase takes
very long.
Cause
The strainer support was not closed
correctly or not appropriately assembled
into the brewing unit and got entangled.
Appliance requires descaling.
The beverage quantity was not set
appropriately.
The water reservoir does not contain
su cient water for preparation of a large
beverage quantity.
The respective strainer support is
clogged.
The temperature was not set
appropriately.
The steep time was not set
appropriately.
The respective strainer support is
clogged.
Technical fault
The appliance has become very hot and
must cool.
Remedy
Fold the bracket closure (B) upwards,
remove the strainer support (C to
E), check for faults/irregularities and
reassemble.
Descale the appliance according
to section "5. Cleaning, care and
maintenance".
Set the desired beverage quantity
according to section "3. Preparation of
beverages".
Please ll the water reservoir (L)
appropriately and assemble.
Clean the respective strainer support
according to section "5. Cleaning, care
and maintenance".
Set the desired temperature according
to section "3. Preparation of beverages".
Set the desired steep time according to
section "3. Preparation of beverages".
Clean the respective strainer support
according to section "5. Cleaning, care
and maintenance".
Contact your competent customer
support desk.
Pleas wait until the brewing process is
started. If applicable, leave the appliance
to cool for a few minutes.
EN
21