Bosch PLR 30 C Notice Originale page 29

Press the measuring button (4) to initiate the measuring process.
Move the measuring tool until the required distance value is shown at
27.589 m
min the bottom of the display.
29.589 m
max
You can pause the continuous measurement by pressing the measur-
ing button (4). The current measured value will be shown at the bot-
28.000 m
tom of the display. The largest and smallest measured value appear
above it. Pressing the measuring button (4) once more will start the continuous meas-
urement again.
Continuous measurement automatically switches off after four minutes.
Deleting measured values
In any measuring function, you can delete the most recently recorded individual meas-
ured value by briefly pressing the on/off button (8). Repeatedly pressing the button
briefly will delete the individual measured values in reverse order.
Adding/subtracting values
Measured values or end results can be added or subtracted.
Adding values
The following example describes the addition of areas:
Measure an area as described in the section on area measurement (see "Area measure-
ment", page 28).
Press the button (1) [+]. The calculated area is shown in the centre
of the display.
+4.324 m
2
0.000 m
2
Press the measuring button (4) to start another area measurement.
Measure the area as described in the section on area measurement
+5.523 m
2 (see "Area measurement", page 28). To complete the addition, press
+4.324 m
2
the measuring button (4). To add more measured values, press the
button (1) [+] again and repeat.
9.847 m
2
Subtracting values
To subtract values, press the button (7) [–]. The subsequent steps are the same as for
the section on adding values.
Bosch Power Tools
English | 29
1 609 92A 4P0 | (18.01.2019)