Dust Extraction; Working With The Machine - Festool KA 65 Guide D'utilisation

Remove the edge band
An edge band was detected
when the machine was switched
on. Request for removal of the
edge band. Press the start but-
ton [1-1] and hold until the edge
band has passed through.
Purging position reached
2
190 °C
Central plate [1-12] has been
lowered completely and moved
MODE
to purging position.
Purging process starts
Start button [1-1] was pressed.
The purging process starts after
one second.
Purging process is carried out
2
190 °C
Adhesive nozzles are open,
pressure has built in the adhe-
sive cartridges. Display of the
current status.
Cooling mode
180 °C
The machine reduces the tem-
perature in cooling mode and
then switches off. Cooling mode
is activated when:
–on/off switch [1-8] is pressed <
1 s
–no controls are actuated for
more than 15 minutes
The machine is switched on
again by pressing the start but-
ton [1-1] or the on/off switch
[1-8].
WARNING
High temperatures on the heating unit and adhe-
sive nozzle!
Risk of burns when touched

Wear suitable protective gloves.

Always hold the machine by the insulated han-
dles [1-3], [1-16]!
0
**
Automatic calculation of currently detected edge
height
Vapours emitted during the glueing process!

Ensure there is good ventilation.

Use an extractor.

Always observe national regulations.
An extractor hose with a diameter of 27 mm can be
attached to the extractor connector [1-6].

Working with the machine

Moving workpiece!
Risk of injury from sliding workpiece

Always secure the workpiece in such a manner
that it cannot move.
Fault symbol
Troubleshooting (chapter Trou-
bleshooting).

Dust extraction

CAUTION
WARNING
13