Intended Use; Preparing For Operation; Initial Operation - Festool KA 65 Guide D'utilisation

Accessories shown or described are sometimes not
included in the scope of delivery.
The edge bander is suitable for:
– Attaching edge bands made of wood, materials
similar to wood and plastic using Festool adhe-
sives.
WARNING
Unauthorised voltage or frequency!
Risk of accident

The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.

In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.

Initial operation


Remove protective foil from underneath the
support base [1-17] and display [1-20].
The machine may generate large quantities
of smoke and a pungent odour when operat-
ed for the first time.
Do not use the machine and working materi-
als below 15 °C. Recommendation: room
temperature.
10

Intended use

The user bears the responsibility for damage and
accidents caused by improper use; this also in-
cludes damage and wear caused by continuous
use in industry.
Operation

Install the support base [2].
2

Insert the plug into an earthed socket.

Insert a minimum of two adhesive cartridges in
the magazine (chapter Refilling an adhesive
cartridge [6]).

Set the heating temperature for the relevant ad-
hesive cartridges.
Temperature selection [1-7] according to the de-
fault setting:
Setting 1 = 190 °C
Setting 2 = 200 °C
The temperature can be adjusted by pressing
the menu buttons [1-19] (chapter Menu but-
tons [1-19]). After independent changes are
WARNING

Preparing for operation

1
2
2
1
2-1