Switching Off; Settings - Festool KA 65 Guide D'utilisation

made, the last temperature used is automatically
saved to the selected setting and replaces the de-
fault setting.
Switching on

Press the on/off switch [1-8] once and hold until
the Festool logo appears on the display [1-20].
The machine increases the temperature in heating
mode until the setpoint temperature is reached
(display [1-20] lights up red).
Machine switches to warming phase (display [1-20]
flashes red/green).
Machine is ready for operation (display [1-20] lights
up green).
NOTE
Do not leave the machine unattended!

When taking a break of less than 15 minutes,
switch the machine to cooling mode (chapter

Switching off).


When taking a longer break, switch off the ma-
chine completely.
Adjusting the edge height [3]
The edge height can only be adjusted at op-
erating temperature! Ignoring this instruc-
tion may result in machine damage.
3
- +
3-1
+
3-2
-
3-3
3-4

Press the on/off switch [1-8] < 1 s
The machine reduces the temperature in cooling
mode and then switches off.
Display [1-20] lights up red, fan symbol is dis-
played.

Press the on/off switch [1-8] and hold > 1 s
The machine switches off immediately.

Settings


Guide the edge band [3-2] into the edge inlet [3-
3].

Use the rotary knob [3-1] to adjust the height of
the edge inlet [3-3] until the edge band [3-2]
rests against the top and bottom of the inlet.

Turn back the rotary knob by one locking posi-
tion so that the edge band [3-2] can slide
through smoothly without becoming caught.
Adapting the adhesive quantity
The necessary adhesive quantity is automatically
adjusted to the current edge height.
Press the menu buttons [1-19] to adapt the adhe-
sive quantity (layer thickness) to different work-
piece materials (chapter Menu buttons [1-19]).
Switching off
11