Adjustment - Bosch PFS 105E Notice Originale

OBJ_BUCH-420-001.book Page 24 Tuesday, February 12, 2008 8:15 AM
24 | English
Adjusting the Spray Pattern (see figure F)
Never actuate the trigger switch 9 while ad-
justing the air cap 2.
– Loosen the union nut 3.
– Turn the air cap 2 to the requested position.
– Firmly retighten the union nut.
Air cap Jet Application
A
Vertical flat jet for hori-
zontal working direction
B
Horizontal flat jet for ver-
tical working direction
C
Round jet for corners,
edges and hard to reach
locations
Adjusting the Spraying Capacity (see figure G)
– To adjust the requested spraying capacity,
turn the thumbwheel 5:
I: Min. spraying capacity,
IIII: Max. spraying capacity.
Spraying capacity
Too much material on tar-
get area:
Not enough material on
target area:
1 609 929 L50 | (12.2.08)
Adjusting the Air Flow (see figure H)
– Turn control knob 16 to adjust the air flow
and the pressure for the spray material being
used.
It is recommended to start with the maximum
air flow.
Air Flow
Too much fog of coating
material:
Atomisation too coarse:
Transport

Adjustment

The filled spray gun or a closed container with
The spraying ca-
spray material can be placed in the set-down
pacity must be re-
port 17 for transport. The holding fixture retains
duced.
the spray gun firmly in the set-down port. Spray
material cannot run out.
– Turn the thum-
bwheel 5 in direc-
– Place down the spray gun on the set-down
tion I.
port and push in against the resistance until
tightly seated.
The spraying ca-
pacity must be in-
creased.
– Turn the thum-
bwheel 5 in direc-
tion IIII.
Minimal air flow Maximum air
flow
Adjustment
The air flow must
be reduced.
– Turn control knob
16 toward the
left.
The air flow must
be increased.
– Turn control knob
16 toward the
right.
Bosch Power Tools