English | 19 - Bosch PFS 105E Notice Originale

OBJ_BUCH-420-001.book Page 19 Tuesday, February 12, 2008 8:15 AM
Do not use materials with a flashpoint be-
low 21 °C for spraying and cleaning. Use
water-based materials, non-volatile hydro-
carbons or similar materials. Fast evaporat-
ing solvents create an explosive environ-
ment.
Do not spray in the vicininty of ignition
sources, such as static electricity sparks,
open flames, pilot lights, hot objects, en-
gines/motors, cigarettes and sparks from
plugging in or unplugging power cords or
operating switches. Such spark sources can
ignite the spraying vicinity/environment.
Do not spray any liquid of unknown hazard
potential. Unknown materials can create
hazardous conditions.
Wear additional protective equipment such
as appropriate protective gloves and pro-
tective masks or respirators when spraying
or handling chemicals. Wearing protective
equipment for the appropriate conditions re-
duces the exposure to hazardous substanc-
es.
Never point the spray jet against yourself,
towards other persons or animals. Keep
your hands and other body parts away from
the spray jet. If the spray jet should pene-
trate the skin, seek medical attention imme-
diately from a doctor. The material being
sprayed can even penetrate the skin through
a glove and be injected into your body.
Do not treat injection as a simple cut. High-
pressure spray is able to inject toxins into
the body and cause serious bodily injury. In
the event that injection occurs, seek medical
attention immediately.
Bosch Power Tools
Be aware of possible hazards from the
spray material. Observe the information on
drums/tanks/tins as well as manufacturer
information of the spray material, including
the request to wear personal protective
equipment. The manufacturer's instructions
are to be observed in order to reduce the risk
of fire as well as injuries caused through tox-
ins, carcinogens, etc.
Use only nozzles/nozzle inserts specified
by the manufacturer. Never spray without
the nozzle protection mounted. Use of a
special nozzle insert with the corresponding
nozzle protection reduces the probability
that a high-pressure jet penetrates the skin
and injects toxins into the body.
Exercise caution when cleaning and chang-
ing nozzle inserts. If the nozzle insert
should become clogged during spraying,
follow the manufacturer's instructions for
switching off the system and relieving the
pressure before removing the nozzle. Fluids
under high pressure can penetrate the skin,
inject toxins into the body and lead to seri-
ous injury.
Keep the plug of the mains cord and the
trigger switch of the spray gun clear of
paint and other fluids. Never hold the cord
by its connectors to support it. Failure to
follow the instruction can lead to electric
shock.
1 609 929 L50 | (12.2.08)

English | 19