Setting The Time; Cleaning The Under-Bench Air Conditioner - Dometic FRESHWELL FW3000 Notice D'utilisation

FreshWell3000
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of them at
collection points.
8.11

Setting the time

The remote control needs the current time in order to program the timer. The time is
indicated on the display of the remote control.
Perform the following steps to set the time:
I
NOTE
The remote control returns to its initial mode and saves the current
setting, if no key is pressed on the remote control for 15 seconds while
setting the time.
➤ Press and hold the
✓ The time flashes on the display of the remote control.
➤ Use the + or – button to set the current time.
Press the + or – button longer than 2 s to increase or decrease the time quicker.
➤ Press the SET button to confirm the time.
9 Cleaning the under-bench air
conditioner
A
NOTICE! Beware of damage
Do not clean the under-bench air conditioner with a high-pressure
cleaner. Exposure to water can damage the air conditioner.
Do not use sharp or hard objects or cleaning agents for cleaning as
these may damage the under-bench air conditioner.
To clean the under-bench air conditioner, use water with a gentle
cleaning agent. Never use petrol, diesel or solvents.
➤ Clean the housing of the under-bench air conditioner and the air outlet unit
occasionally with a damp cloth.
➤ Regularly remove leaves and other dirt from the ventilation grilles (fig. 4 1,
page 3) of the under-bench air conditioner. Make sure you do not damage the
grilles in the process.
EN

Cleaning the under-bench air conditioner

button in order to get into the mode for setting the time.
23