EN Wall, ceiling and floor grinding machine WDS 530 E
1 Important information
Key to the illustrations
Pos
Fig.
Designation
37
P
3 x Retaining screw
38
P/S
Retaining ring
39
P/S
ETX-carrier
40
Q
Screw
41
Q
3 x Milling drum
42
Q
Drum mount
43
R
Gear disc
44
R
Cover
45
S
3 x Recess
46
U
Special dust cover ring
47
Z
Inclinometer
48
AA
Controller,
49
AA
Controller,
wall / ceiling / floor contact pressure
50
AB
Contact pressure display (bar)
51
AD
3 x Drive plate
52
AD
3 x Screw
53
AD/AE Clamping screw
54
AD/AE Star grip
55
AE
Spanner
1
) Not included in scope of delivery /
1 Important information
The grinding machine may be used only with the ac‐
cessories supplied by the manufacturer for stripping
and grinding of even wall and ceiling surfaces or even
floor surfaces such as:
— concrete
— natural stone
— plaster
— residual adhesive or filling compound
— paint
Any other use of the grinding machine can lead to
endangerment and is prohibited!
To ensure proper use of the machine, follow the in
structions in the operating manual, paying particular
attention to any warnings and instructions relating to
operation and maintenance!
Before using the grinding machine,
the operating personnel must carefully
read and understand this operating
manual!
Keep this operating manual close at
hand for easy reference!
Read and observe operating manuals for the guiding
machine provided by suppliers!
20
2
)
2
)
2
)
2
)
floor counter pressure
1
)
2
) accessories
If the grinding machine is loaned to other parties, the
operating manual needs to be provided with the
machine and its importance must be made clear!
1.1 Symbols used
The following symbols are used in this
documentation:
Safety instructions
This symbol indicates warnings, prohibitions and
instructions regarding potential hazards. These
instructions must be obeyed and closely
observed.
Some safety instructions are accompanied by
corresponding symbols.
Warning
Additional information
This symbol indicates additional information.
1.2 Copyright, liability and warranty
Schwamborn Gerätebau GmbH
All rights, including those pertaining to translation, lie
with Schwamborn Gerätebau GmbH.
Any reproduction, use or distribution of this original
operating manual or its translations, in whole or in
part, is prohibited without the express written permis
sion of Schwamborn Gerätebau GmbH.
Liability or warranty is excluded if:
—
The instructions in the operating manual have
not been observed.
—
The grinding machine or its attachments were
improperly operated.
—
The maintenance was carried out inadequately
or incorrectly.
—
Specified original spare parts were not used.
—
The protective equipment was not used, has
been altered or was removed.
—
The specified power supply ratings and sur
rounding conditions have not been observed.
—
The tool speed has been set too high
(! Chapter 3.2, Pos. 4.).
—
An unsuitable dust extraction has been used.
Prohibition
Direction