JVC KD-R975BTS Manuel D'instructions page 39

(for KD-R870BT / KD-R770BT / KD-RD97BT / KD-RD87BT)
Wiring connection
IMPORTANT
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult your
car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Blue: To power antenna
Blue/white: To amplifier
Brown
Recommended connection
Output terminals ( 33)
Antenna terminal
To the steering wheel
remote control adapter
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
(Not used)
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker/For 3-way crossover: mid range speaker (right)
Gray/black
White: Front speaker/For 3-way crossover: mid range speaker (left)
White/black
Purple: Rear speaker/For 3-way crossover: Tweeter (right)
Purple/black
Green: Rear speaker *
2
Green/black *
Light blue/yellow
STEERING
WHEEL
REMOTE
2
/For 3-way crossover: Tweeter (left)
Signal cord
(not supplied)
Fuse (10 A)
Microphone input jack ( 14)
Remote wire (not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if your vehicle
factory wiring harness does not have
"12 V ignition switch" wire.
* 1
Firmly connect the ground wire of the
amplifier to the car's chassis to avoid
damaging the unit.
* 2
You can also connect a subwoofer speaker
directly using this lead without an external
subwoofer amplifier. For setting, 22.
ENGLISH
1
JVC Amplifier *
35