Wiring Connection; Important - JVC KD-R975BTS Manuel D'instructions

(for KD-R975BTS / KD-R970BTS / KD-R97MBS / KD-R875BTS)

Wiring connection

IMPORTANT

We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult your
car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring
harness
Blue: To power antenna
(separately
Blue/white: To amplifier
purchased)
Brown
Recommended connection
34
Output terminals ( 33)
Antenna terminal
To the steering wheel
remote control adapter
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
(Not used)
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker/For 3-way crossover: mid range speaker (right)
Gray/black
White: Front speaker/For 3-way crossover: mid range speaker (left)
White/black
Purple: Rear speaker/For 3-way crossover: Tweeter (right)
Purple/black
2
Green: Rear speaker *
2
Green/black *
Fuse (10 A)
Light blue/yellow
STEERING
WHEEL
REMOTE
/For 3-way crossover: Tweeter (left)
Signal cord (not supplied)
MIC (Microphone input
terminal) ( 14)
(For KD-R975BTS)
USB cable (DC 5 V
(approx. 1.2 m/4 feet)
Expansion port (12 V 500 mA)
To the optional SiriusXM Vehicle Tuner
(commercially available) ( 11)
Remote wire (not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if your vehicle factory wiring
harness does not have "12 V ignition switch" wire.
* 1
Firmly connect the ground wire of the amplifier to the
car's chassis to avoid damaging the unit.
* 2
You can also connect a subwoofer speaker directly
using this lead without an external subwoofer
amplifier. For setting, 22.
1
JVC Amplifier *
1.5 A)