Cleaning And Care - GUTMANN Brillante Notice D'utilisation

until the indicator lamp goes out. The
grease filter indicator is activated after max.
15 operating hours or every two weeks(even
if no cooking operations take place).
Room ventilation
Pressing the Automatic Cool Down Period
button and the Clean Grease Filter Alert
symbol button at the same time activates/
deactivates the room ventilation function.

Cleaning and care

Cleaning of the surface
Risk of electric shock! Please separate the
extractor hood from the power supply
network by pulling the plug or the
disconnection of the fuse. Please pay
attention to the fact that no water seeps into
the appliance during the cleaning process.
Untimely cleaning of the surface saves later
a troublesome removing of stubborn
soiling. For the cleaning use only
commercial detergent or all-purpose
cleaners which are suitable for stainless
steel / aluminium.
scouring agents or steel wool!
cleaning of the extractor hood please tend
the stainless steel surfaces with a high-
grade steel-care product.
Only with a light soapy water and a very soft
cloth varnished surfaces have to be
cleaned. Please clean the switch panel only
with a soft and damp-dry cloth.
By extractor hoods with a pane beneath the
metal grease filter ("Perimeter Extraction")
fatty deposits can occur on the edge of the
pane. These deposits are founded
physically and represent no dysfunction of
the extractor hood. Please clean the pane
beneath the filter regularly to prevent
stubborn soiling.
Cleaning and care instructions
When cleaning the grease filters, also
remove any grease deposits from the
accessible housing components. This will
prevent a fire hazard and maintain an
optimum range of functions. Use hot soapy
water or a mild window cleaning agent to
clean the hood. Do not scratch off baked-
on deposits. Soften them using a damp
Please do not use
After the
cloth. Do not use abrasive agents or
scouring pads.
Note: Do not use alcohol (spirits) on plastic
surfaces, as dull spots may result.
Caution: Ventilate the kitchen sufficiently, no
open flame.
Only clean the operating panel with a soft
damp cloth (mild detergent solution). Do
not use stainless steel cleaners for the
sliding switch/pressure switch.
Stainless steel surfaces:
Use a mild and non-abrasive stainless
steel cleaning agent. Do not clean stainless
steel surfaces with abrasive scouring pads
or with cleaning agents containing sand,
soda, acid or chloride! Clean in direction of
polish only.
We recommend our stainless steel clea-
ner no. 461731. See the enclosed service
booklet for the order address.
Aluminium, varnished and plastic
surfaces:
Use a soft microfibre cloth. Do not use dry
cloths. Use a mild window-cleaning agent.
Do not use aggressive cleaning agents or
agents containing acid or lye! Do not use
scouring agents.
Exchange and cleaning of the filter
Fire risk! The performance of the extractor
hood is affected by containing fat remains
and therefore the fire risk increases. To
prevent a fire risk please clean the metal
filter regularly. The metal grease filter must
be cleaned every 2 weeks at last.
By models with a pane beneath the filter
("Perimeter Extraction") the pane has to be
removed at first.
small front glass pane with one hand
upwards and then take the filter out at its
grip. The metal grease filter is fixed by a
magnet. The installation is made in reverse
order.
The metal grease filter is to be cleaned at
best in a dishwasher or in hot soapy water.
Aggressive cleaners should not be used.
The guarantee can´t be applied if a
discolouring on the filter is a result of using
an aggressive dishwashing liquid. Please
avoid temperatures over 55 degrees.
For this swing at first the
en