Priming The Water Circuit - Philips Saeco Syntia RI9836 Mode D'emploi

• Turn the machine ON by pressing the
power switch to "I".
• The display shows the ON/OFF icon.
Black
• Make sure the ON/OFF button is set to
the " " position; if this is not the case,
set it to that position.
• Press the ON/OFF button to turn the
machine on.
• The display indicates that the circuit
must be primed.
Red
Note: Before starting the
machine after long periods
of inactivity, the water circuit must
be primed.
• 30 • • 30 •

Priming the Water Circuit

• To prime the water circuit, place a
container under the steam/hot water
wand(Pannarello, if supplied).
• Turn the selector dial clockwise to set
it to the "
starts the automatic priming of the
circuit by letting out a preset quantity
of water through the steam/hot water
wand (Pannarello, if supplied). The bar
under the icon shows the operation
progress.
At the end of the priming process,
the display shows an icon (see fig-
ure) indicating that the selection dial
must be brought back to the central
" " position.
Red
• The display then shows the machine
warm-up icon, as shown in the fi gure.
Orange
When warm-up is complete,
the machine performs a rinse
cycle of the internal circuits.
In this phase, this icon will be dis-
Orange played:
• When the operations described above
are complete, this icon will be dis-
played:
The machine is then ready to brew
Green
beverages.
• To brew coff ee, dispense hot water or
steam, and for a proper use of the ma-
chine, carefully follow the instructions
provided.
If the machine is being used
for the fi rst time or after a
long period of inactivity, follow the
operations described in the follow-
ing section.
" position. The machine