Arktic KITCHEN LINE 232019 Mode D'emploi page 12

Symbol
EN
Operation of control panel
Changing the set value
• In order to display the set value, press and imme-
diately release the [SET/MUTE] button.
• Press and hold the [SET/MUTE] button for at least
1 seconds to change the set value. The current
set value will be displayed.
Setting the default parameters
To reset the default parameters:
• disconnect power from the instrument;
• reconnect power while holding the [SET/MUTE]
12
Name Type Mode
Press and hold for min.
3 seconds
Up/Switch Button
Press and release
Press and hold for min.
3 seconds
Down/
Button
Defrosting
Press and release
Press and release
Press and hold for min.
Set/Mute Button 1 second
Press and hold for min.
3 seconds
Aux Light Illuminated
Clock (RTC) Light Illuminated
Alarm Light Illuminated
Illuminated
Cooling
Light
Fan
Blinks
Illuminated
Defrosting Light
Blinks
Illuminated
Compresor Light
Blinks
Meaning
Switch ON/OFF
Scrolling functions; increasing the value of the se-
lected parameter (In the programming mode)
Manual defrosting will start
Scrolling functions; decreasing the value of the se-
lected parameter (In the programming mode)
Mutes the audible alarm
Displays/sets the set point
Accesses the parameter setting menu
The additional output active (service mode only)
RTC available, enabled (tEN=1) and at least one
time band has been set (service mode only).
Alarm in progress
Fan activated
The start of fan is delayed due to external shut-off;
other procedure is in progress
Defrosting in progress
The start of defrosting is delayed due to external
shut-off; other procedure is in progress
Compressor on
The start of Compresor is delayed by protective
procedure
• To change the set value, press the [UP/SWITCH]
or [DOWN/DEFROSTING] arrows. To store the
new set value, press the [SET/MUTE] button
again or wait 15 seconds.
and [DOWN/DEFROSTING] buttons;
• the display will show the message "CF";
• after a few seconds the instrument starts oper-