DEJELIN NutriVac NV280 Série Mode D'emploi page 63

VACUUM PACKING WITH NUTRIBOX
The NutriVac Vacuum & Seal function
can be used to vacuum pack
NutriBox boxes. This is done using
the connecting tube to be positioned
between the NutriVac's air evacuation
outlet and the NutriBox boxes.
IMPORTANT: liquids must be
cooled before being vacuum
packed. Otherwise, there is a risk
of overflowing during vacuum
packing.
1. Fill the NutriBox box, leaving a
gap of at least 3 cm from the top
edge of the box
2. Put the lid on the box to close
3. Connect the lid of your box
to your NutriVac using the
connecting tube
4. Press the "Vacuum & Seal" button
5. The vacuum packing process will
EN
take a maximum of 6 minutes
and will stop automatically
6. Check that the vacuum has
been created using the "vacuum
indicator". If the NutriBox is
correctly emptied of air, the
pipette must have gone fully
back into the lid
63