Hold-Down Clamp And Centre Stop; Hold-Down Clamp - Hettich BlueMax Mini Modular Instructions De Service

Setting up

7. Hold-down clamp and centre stop

Hold-down clamp

Depending on panel thickness, hold-down clamps must be
vertically adjusted.
Workpiece and hold-down clamp foot
apart by no more than 6 mm (if necessary, place an A/F 5
mm Allen key spanner underneath).
To set spacing, undo clamping screw
down clamp in its retainer.
1
Tighten clamping screw once correct height is achieved.
Note!
The compressed-air supply must be switched off
when performing this setting work!

Hold-down clamp

must be moved into position to ensure
1
workpiece is securely clamped in place for drilling.
Undo clamping levers to set the hold-down clamp.
4
Re-tighten clamping levers after positioning.
Caution!
Do not move the arm under the drilling head.
144
must be spaced
3
1
and re-position hold-
2
1
max. 6 mm
4 4
2
3