Concluding Start-Up - Hettich BlueMax Mini Modular Instructions De Service

11. Concluding start-up

• After completing all servicing and set-up work,
make sure everything has been done properly.
• Check all screws and connections for secure fit.
• After completing the check, you should carry out a
test using a component.
• Start-up may only be concluded once the machine
is working properly.
• Now switch the machine off and hand over
production to the operator.
• The operator must always be informed about the
production settings currently in effect and given
instruction on work procedure.
• Production can now commence.
Note!
Following servicing work, check all safety
guards for proper working order.
135