IWC Schaffhausen Ingenieur Dual Time 3244 Mode D'emploi page 28

— 2 8 —
F u n c t i O n s O F t h e c r O W n
X 0 1 2
Normal position (screwed in)
X —
Winding position
0 —
Hour and date setting
1 —
Time setting
2 —
n O r M a l p O s i t i O n
This watch has a screw-in crown. Screwing the crown in to its
normal position (X) prevents the inadvertent adjustment of the
time, the 24-hour hand or the date, and also acts as a double seal
to prevent water from seeping into the case. To release the crown,
unscrew it by turning it to the left, where it automatically assumes
position 0, the winding position. By depressing the crown into
position X and turning it to the right at the same time, it is screwed
down firmly again and secured.
i n g e n i e u r d u a l t i M e