Checks Before Use; Connecting To The Power Supply - Carat T-3510 Mode D'emploi

8 8

7. Connecting to the power supply

CAUTION !
This machine must be connected to the power
supply, protected by a trip switch or a class II
insulating transformer,
characteristics:
Trip Switch
Transformer
N.B. To use the trip switches correctly, do not
forget to check that they are working properly
from time to time, by pushing the relevant button
on the front of the unit itself.
- Make sure that the section of the conductors in
the power supply cable is sized in accordance
with the starting current and length of cable.
For cables of up to 50 m long, a section of
4 mm 2 is sufficient.
- Before connecting the machine to the power
socket make sure that the power supply voltage
is the same as that indicated on the machine's
plate.
- Only connect this machine to power supplies
that are efficiently earthed. In case of doubt do
not connect this machine up.
with the following
In 25 A Id 30 mA
230 V 50 Hz 4000 W
Continuous operation

8. Checks before use

CAUTION !
THE T-3510 IS DESIGNED TO WORK WITH
WATER.
- Before starting to cut make sure that the water
level in the tank is as shown in the photo.
9 9
- Make sure that the power supply cable cannot
get caught up in the cutting operations.
Use the cable clamp lever to keep it in place.
1 1 0 0
CAUTION !
Check that the power is on before using the
machine.
31
GB