Carat T-3510 Mode D'emploi page 30

GB
- The legs are in the moving position
(photo 5).
TO MOVE THE MACHINE:
a) Use a four-part sling, connected to the hooks in
the moving handles (photo 4).
4 4
b) With the help of another person, move the
machine using the carrying handles (photo 5).
5 5
6. Moving wheels kit
The machine can be moved by one person, using
the "moving wheels" accessory.
CAUTION !
IN ORDER NOT
STABILITY OF THE MACHINE, FOLLOW THE
INSTRUCTIONS BELOW CAREFULLY.
SUPPORT THE MACHINE WHILE MOVING IT.
With the machine in a working position:
a) Slacken the lock on the left leg (motor side).
b) Lift the leg and insert it into the wheel support
(photo 6).
c) Lock the leg in position using the leg lock.
TO COMPROMISE
6 6
d) Tighten the wheel support screws (photo 6).
e) Repeat this operation on the right leg.
INFORMATION
TO FACILITATE MOVING THE T-3510 ON SITE, IT
IS ADVISABLE TO PUT IT IN THE LOWERED
POSITION.
a) Slacken the leg locks on the front one at a time,
supporting the machine by the carrying handles.
b) Lower the front of the machine by allowing the
legs to slide into the supports until the middle
hole on each leg is aligned with the hole in the
support.
7 7
THE
c) Lock the legs in position using the relevant
clamps.
d) Repeat the operations indicated under a), b)
and c) for the rear (motor side).
MOVE THE MACHINE AS SHOWN IN PHOTO 8.
30