Carat T-3510 Mode D'emploi page 35

CAUTION !
ALWAYS KEEP A SAFE DISTANCE BETWEEN
THE OPERATOR'S EYES AND THE END
OF THE LINE.
CAUTION !
THE MANUFACTURER
RESPONSIBILITY WHERE THE LASER MARKER
IS USED OTHER THAN AS INDICATED.
13. Maintenance
CLEANING
CAUTION !
DO NOT WASH THE MACHINE USING WATER
JETS UNDER PRESSURE.
Drain working residue from the machine using the
plug on the bottom of the collection tank.
Clean the sprayer from time to time as shown
(photo 22 and 23).
2 2 2 2
2 2 3 3
ACCEPTS NO
35
Clean cutting residue off the sliding guides from
time to time. (photo 24).
2 2 4 4
ADJUSTING THE ANGLE ON THE MOTOR HEAD
The cutting head has a scale for adjusting the cut to
be square or at 45°.
Should these angles be found to be incorrect over
time, proceed as follows:
1) Slacken the adjustment tightening nut using a
13 mm spanner.
2) Adjust the scale to the correct position using a 6
mm Allen wrench.
3) Tighten the scale once again using the
tightening nut.
2 2 5 5
CAUTION !
TO POSITION THE SCALE PROPERLY, USE A
45° SET SQUARE.
ADJUSTING THE SLIDING CARRIAGE
The sliding carriage is fitted with an adjustment
scale.
When excess lateral
movement occurs, proceed as follows:
1) Using a 13 mm spanner and a 6 mm Allen
GB
and vertical carriage