Gmhdh-3Pt Models - Hatco GLOMAX GMHD Série Manuel D'installation Et D'utilisation

OPERATION

GMHDH-3PT Models

Startup
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See
the SPECIFICATIONS section for details.
2. Move the Power I/O (on/off) switch to the I (on) position.
• The temperature display will show the current
temperature of the cabinet and the humidity display will
show the humidity of the cabinet.
• If the water reservoir is low with water, the low water
indicator light will illuminate and will buzz. Press the
key or key to cancel the buzz.
NOTE: The temperature and humidity displays will show
the software version at first before displaying the
temperature and humidity of the cabinet.
3. Fill the water reservoir with clean water. To fill the reservoir:
a. Lift up the water fill cup cover and pull forward.
b. Slowly pour water into the water fill cup until the water
fill cup is full.
IMPORTANT NOTE
When using distilled water, add one teaspoon of salt to
the water reservoir during the initial water fill only. This will
ensure proper operation of the water level sensors.
WARNING
ELECTRIC SHOCK HAZARD: Do not overfill water
reservoir. Overfilling can cause electrical shock.
NOTE: The capacity of the water reservoir is 3.4 liters
(3.5 quarts).
4. Set the air temperature to the desired temperature (refer
to the "Setting the Air Temperature" procedure in this
section).
5. Set the humidity to the desired level (refer to the "Setting
the Humidity" procedure in this section).
6. Allow the unit 30 minutes to reach operating temperature
before loading the cabinet with pre-heated food product.
Drain Outlet Hose
Low Water Indicator Light
Water Fill Cup Temperature Display
Digital Temperature/Humidity Controls
Control Panel–GMHDH-3PT Models
Shutdown
Perform the following steps for shutdown of all models.
1. Move the Power I/O (on/off) switch on the base to the O
(off) position.
2. Perform the "Daily Cleaning" procedure in the
MAINTENANCE section of this manual.
Sliding
Door
Water
Fill
Cup
Drain Outlet
Hose
Control Panel
GMHDH-3PT Model
Humidity Display
8
1.
2.
3.
4.
1.
2.
1.
2.
3.
4.
5.
1.
2.
3.
4.
1.
2.
1.
2.
3.
4.
5.
Power I/O (on/off) Switch
Form No. GMHDCEM-0918