Hatco GLOMAX GMHD Série Manuel D'installation Et D'utilisation page 9

Setting the Air Temperature
1. Press the key to enter temperature setting mode.
The temperature display will show the current temperature
setting.
2. Press the key or
temperature. The temperature range is 20°–85°C
(68°–185°F) in single degree increments. The temperature
setting will begin to increase or decrease rapidly when
holding the key or
3. Press the key to save the setting or wait 5 seconds.
Setting the Humidity
1. Press the key to enter humidity setting mode. The
humidity display will flash the current relative humidity
(RH) setting.
2. Press the key or
humidity. The humidity setting will begin to increase or
decrease rapidly when holding the
2 seconds. Use the table below for reference.
Temperature (°C)
20–59
60–79
80–85
3. Press the key to save the setting or wait 5 seconds.
NOTE: Temperature and humidity settings may vary depending
upon product make-up and consistency. The
temperature display shows the average temperature
point inside the cabinet, not the product temperature.
The capacity of the water reservoir permits uninterrupted
operation for approximately 3–6 hours, depending on the
settings and how frequently the door is opened. WARNING!
ELECTRIC SHOCK HAZARD — Do not overfill water
reservoir.
Form No. GMHDCEM-0918
key to reach the desired
key for 2 seconds.
key to reach the desired
key or
Humidity Range (%RH)
10–80
10–50
10–40
key for
9
OPERATION