Maintenance And Inspection - Hitachi CL 10D Mode D'emploi

English
(4) Attachment
1 When using an M6, M8 or M10 cutter
Insert the cutter in the cutter attachment groove on
the bracket, insert the special spacer between the
cutter and the bracket and then use the hex. socket
hd. bolt to tighten and secure.
2 When using the W3/8" cutter
Insert the cutter in the cutter attachment groove on
the bracket and then use the hex. socket hd. bolt
to tighten and secure.
Size
M10
M8
M6
W3/8"
CAUTION
Use special cutters and spacers that conform with the size
of the screw. Using cutters and spacers of the wrong size
or confusing them can lead to damage to the stud and
cutter.

MAINTENANCE AND INSPECTION

CAUTION
Be sure to remove the rechargeable battery from the unit
during inspection and cleaning.
1. Care after use
After use, use a brush to brush off the work area,
especially the area around the blade.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so could result in serious hazard.
9
NOTE
Spacers are not required when using the W3/8"
cutter.
CAUTION
The hex. socket hd. bolt should be sufficiently tightened
with the hexagonal wrench.
Bracket (A)
Hex. socket hd. bolt
Cutter
Spacer
Bracket (A)
Hex. socket hd. bolt
Cutter
3. Cleaning on the outside
When the power tool is stained, wipe with a soft
dry cloth or a cloth moistened with soapy water.
Do not use chloric solvents, gasoline or paint thinner,
for they melt plastics.
4. Storage
Store the power tool in a place in which the
temperature is less than 40°C and out of reach of
children.
NOTE
Due to HITACHI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
Attachment
Cutter
Spacer
Hex. socket hd. bolt
Bracket (B)
Cutter
Hex. socket hd. bolt
Bracket (B)