Hach RTC Standardized Combined CX5130 Manuel D'installation page 9

Figure 4 Connect the power supply
1 +24 VDC
CP27xx—Power supply
Connect the power supply of the CP27xx through a 8-pole plug connector. The CP27xx does not
have a mains power switch. When the power supply is set to ON the CP27xx is energized. For a
correct pin assignment refer to
Note: The connector is specified for 16 A and can lift conductive cross-sections to a maximum section of 1.5 mm
2 0 VDC
Figure 5.
2
.
English 9