Cavist XV3 Manuel D'utilisation page 9

Switching on the appliance and setting the temperature
Follow the below steps to switch on the appliance and set the required temperature:
Switch the appliance on at the plug, then press and hold the power on/off control button for
1.
at least 5 seconds. The appliance will beep and the internal temperature of the appliance will
be shown on the display.
The temperature setting for the appliance is adjustable within the range of 5°C to 22°C or
2.
40°F / 72°F.
When you press the temperature up or temperature down controls for the first time, the LED
3.
display will show the factory default temperature setting of 12°C / 54°F.
Use the temperature up and temperature down controls to set the desired internal
4.
temperature.
The temperature will increase by 1°C or 1°F if you touch the temperature up control once and
5.
will decrease by the same amount if you press the temperature down control once.
When you set a new temperature, the display will show the previous temperature for 5
6.
seconds, before showing the actual temperature. During this time, the cooler temperature will
adjust accordingly.
To view the set temperature in the wine cooler, press the temperature up) or temperature
7.
down control. The display will flash the temperature for 5 seconds.
Note: We recommend that the door is not opened for a minimum of 4 hours to allow the appliance
to reach the standard operating temperature.
Note: The temperature of the drinks and how often the door is opened affects the temperature in
the cooler. If required, change the temperature setting.
Note: Cool air falls and warmer air rises, so there will be a slight temperature variation between
the top of the cabinet and the bottom of the cabinet.
Important: When the temperature is changed, the compressor works harder to reach the required
temperature. During this time, the side panels of the wine cabinet can reach up to 45°C however
they will cool down when the set temperature is reached.
Changing between Fahrenheit and Celsius
You can select whether the temperature display shows Celsius or Fahrenheit:
To change the temperature reading from Celsius to Fahrenheit you must press and hold the
1.
light on/off control until the appliance beeps and the °F indicator will be lit.
You cannot change the display if you are in the process of adjusting the temperature of the
2.
wine cabinet.