Coding Of The Decomposition Vessel; Opening The Decomposition Vessel; Fastening Cotton Thread; Closing The Decomposition Vessel - IKA C 5010 Mode D'emploi

Coding of the decomposition vessel

The label set included in the delivery quantity is used for coding. The indivi-
dual strips are glued into the respective grooves around the decomposition
vessel.
Decomposition vessel - no. 1 (without coding) 2
3 4
Groove for
coding

Opening the decomposition vessel

• Unscrew union nut
Handle
• Use the handle
in order to pull out
the cover.
Cover
Union nut
The decomposition vessel consists of the following individual parts:
Union nut
Oxygen valve
Electrical
igniton
Cover
wire
Crucible
Igniton wire
Crucible holder
20

Fastening cotton thread

The decomposition vessel is
equipped with a fixed ignition
Cotton thread
wire.
A cotton thread has to be fastened
to the ignition wire in order to
carry out combustion.
Fasten cotton thread as shown in
the diagram.
Note: Beware the danger of burn-off
in the case of incorrectly laid ignition
wires!
Cotton thread

Closing the decomposition vessel

• Place the cover onto the lower section and push down until it presses
against the stop piece in the lower section.
C 5010 C 5012
C 5010 C 5012
• Place the union nut onto the lower section and tighten by hand.
C 5010 C 5012
• The decomposition vessel can now be filled.
21