Troubleshooting - Qlima PGP 113 Manuel D'utilisation

• Do not paint the flame screen, control panel or reflector.
• Cover the burner unit with the optional supplied protective cover when the
heater is not in use. Wait until the heater is cool before covering.
• In a salt-air environment, such as near an ocean, corrosion occurs more quick-
ly than normal. Check frequently for corroded areas and repair them prompt-
ly.

TROUBLESHOOTING

Review these tips first and you may not need to call for service.
Problem
Pilot will not light
Pilot will not stay on
Burner will not light
Burner flame is low
Burner flame goes
off immediately
after ignition
Probable cause Solution
Gas valve may be OFF Turn the gas valve ON.
Tank fuel empty Refill gas tank.
Pilot injector blocked Clean or replace pilot injec-
tor.
Air in supply system Purge air from lines by pres-
sing the control knob until
you smell gas.
Loose connections Check all fittings.
Low gas pressure Replace cylinder with a new
cylinder.
Battery is empty Replace battery with a full
battery
Lack of fuel pressure Keep the variable knob
depressed for 10-20 seconds
or more after the pilot light
ignited.
Tank near empty. Refill gas
tank.
Debris around pilot Clean dirty area.
Loose connections Tighten connections.
Thermocouple bad Replace thermocouple.
Gas Ieak in Iine Check connections.
Pressure is low Tank near empty.Refill gas
tank.
Opening blocked Remove and clean.
ControI is not 0N Turn valve to ON.
Thermocouple bad Replace thermocouple.
Pilot light assembly Place pilot properly.
bent
Not in correct location Position properly and retry.
Supply hose is bent or Straighten hose and per-
twisted form leak teston hose.
Blockage in burner Clean or replace burner
injector injector.
Low gas pressure Let the pilot flame stay lit
for 10 minutes before set-
ting variable knob to LO.
4
53