Maintenance - Mac allister MSSP120 Notice Originale

MSSP120

Maintenance

WARNING!
Switch the machine off and disconnect it
from the mains voltage before carrying out
any maintenance and adjustment works.
The golden rules of care
1. Keep the instructions near the machine.
2. Keep the machine clean.
3. Wear protective goggles when cleaning the
machine.
4. Inspect the product before each use for worn
and damaged parts. Do not operate it if you
find broken or worn parts.
• Check the saw blade regularly. Only use sharpened, crack­free and
non­deformed saw blades.
• Replace a worn bench insert immediately.
• Always keep the bench surface free of resin.
• Clean the inside of the machine such as tooth segment and bevel of the
tilting system regularly from residual wood and splints.
• Remove possible saw dust obstructions at the ejector.
In general:
• Re­application of the wax coating on the workbench makes feeding the
workpiece to the blade easier.
• Ensure that the connection cables are in a good condition and do not have
any cuts.
• Ensure that the moving parts are aligned perfectly, firmly attached and not
obstructed in their movement.
Maintenance
GB
35