Mac allister MSSP120 Notice Originale page 24

MSSP120
GB
Assembly
Mounting the saw on a work bench (Fig. 3)
1. A workbench made from solid wood is betier than one made of plywood, as
interfering vibrations and noise are more noticeable with plywood.
2. The necessary tools and small parts for assembling the saw on a work­
bench are not supplied with the saw. However, use equipment of at least
the following size:
1 ­ Saw body
2 ­ Foam rubber base
3 ­ Work bench
4 ­ Flat seal 9/321.0 7mm (4x)
5 ­ Washer 9/321.0 7mm (4x)
6 ­ Hexagonal nut 1/4­20 (6mm 4x)
7 ­ Hexagonal nut 1/4­20 (6mm Lock nut 4x)
8 ­ Hexagonal bolt 1/4­20 (6mm) x length (4x)
3. First of all, drill holes into the seating surface and then insert the screws.
4. A foam rubber base for reduction of noise is not supplied with the saw ei­
ther. However, we expressly recommend that you use such a base to keep
vibration and noise to a minimum. Ideal size 400 x 240 mm
Fig. 3
24
Important!
If the machine has a tendency to move or tilt
during operation, it must be restrained in the
workspace by four screws (not provided).
Note! All bolts should be inserted from the
top. Install the lock washers and hex nuts
from the underside of the workbench.
Assembly