Working Instructions - Mac allister MSSP120 Notice Originale

MSSP120
• Tighten the blade with the clamping lever (Fig. 7.3) by pressing down on it
again. Check the tension of the blade. If the tension is too low, increase it
by turning it in a clockwise direction. First slacken the clamping lever again.
• Insert the table insert.
Note!
Always fit the saw blade with the teeth
facing in the direction of the sawing table.

Working instructions

IMPORTANT!!!
• After every new adjustment we recommend you to
• Take extra care when starting the cut!
• Never use the equipment without the suction
Basic operation
A scroll saw is fundamentally a „curve cutting tool" but which can also carry
out straight and angled edge cuts. Familiarise yourself with the following
important points prior to commissioning the saw.
Fig. 9
16
make a trial cut in order to check the new settings.
function. Regularly check and clean the suction
channels.
Working instructions
Fig. 8
Fig. 10 Fig. 11
GB
33