Assembly - Mac allister MSSP120 Notice Originale

MSSP120

Assembly

Blade guard assembly and hold-down clamp, (Fig. 1-2)
1. Assemble the workpiece holder (Fig. 1, A) to the clamp (Fig. 1, B) as
shown in the image. This must be fixed first to the machine with the tommy
screw (Fig. 1, C).
2. Install the blade guard (2) to the holder as shown in the diagram. Secure
the screw (2a) with the self­locking nut (2b) (Fig. 2).
3. Screw the flexi-hose (4) into the opening provided and tighten it hand-tight.
4. Lift the saw onto the frame and base and push it onto the workbench.
5. Familiarize yourself with the saw operating elements and features.
Fig. 1
C
A
12
2b 2a
2
Attention!
Ensure that the machine is disconnected
from the mains supply.
B
13
2a
Fig. 2
2b
2
Assembly
4
GB
23