Mac allister MSSP120 Notice Originale page 17

MSSP120
General Safety
ensure that the connections are made and used properly.
Do not use the mains lead for purposes for which it was not intended.
12
Do not use the mains lead to pull the plug out of the mains socket.
–
Protect the mains lead from heat, oil and sharp edges.
Securely support the workpiece
13
An additional support is necessary for long workpieces (table, trestle,
–
etc.) in order to prevent the machine from tipping over.
Use clamps or a vice to grip the workpiece firmly. This is much safer
–
than holding it with your hand.
Avoid placing your body in an unnatural position.
14
Make sure that you have secure footing and always maintain your
–
balance.
Avoid awkward hand positions in which a sudden slip could cause one
–
or both hands to come into contact with the ginding wheel/belt.
Take care of your tools
15
Keep cutting tools sharp and clean in order to be able to work better
–
and more safely.
Follow the instructions for lubrication and for tool replacement.
–
Check the connection cable of the electric tool regularly and have it
–
replaced by a recognised specialist when damaged.
Check extension cables regularly and replace them when damaged.
–
Keep the handle dry, clean and free of oil and grease.
–
Pull the mains plug out of the mains socket.
16
Never remove loose splinters, chips or jammed wood pieces from the
–
running saw blade.
During non­use of the electric tool or prior to maintenance and when
–
replacing tools such as saw blades, bits, milling heads.
Make sure that no spanners, keys etc. are left attached.
17
Check before switching on that all spanners, keys and setting tools
–
have been removed.
Avoid unintentionally starting up the device.
18
Check that the switch is set to OFF on the device when the mains plug
–
is inserted into the mains socket.
Using an extension lead for working outdoors.
19
Only use approved and appropriately identified extension cables for
–
use outdoors.
Only use cable reels in the unrolled state.
–
Safety
GB
17