Mac allister MSSP120 Notice Originale page 34

MSSP120
GB
• The saw does not automatically cut wood. You must feed the wood against
the saw blade manually.
• The cutting process occurs on I y while the blade is moving downwards.
• Feed the wood slowly against the saw blade as the saw blade teeth are
small and cut only while moving downwards.
• AlI persons carrying out work with the saw require training. The saw blade
may break easily during this training time while the operator is still unfamiliar
with the saw.
• The saw is best suited tor sheets of wood less than 2.5 cm thick.
• Feed the wood especially slowly against the blade and avoid abrupt curves
to prevent the saw blade from breaking, if you wish to cut wood sheets thick­
erthan 2.5 cm.
• Saw blade teeth blunten over time, saw blades must be replaced. The saw
blades are sufficient tor 1/2 to 2 operating time depending upon the type of
wood.
• Try and make sure that the saw blade follows the grain of the wood in order
to obtain a clean cut.
• The saw speed must be reduced to minimum when cutting precious and
non­terrous metals.
Inside cuts
This saw is suited also to inside cuts cuts not starting at the edge of the work
piece. Proceed as follows:
• Drill a 6 mm hole in the work piece.
• Loosen the blade tension er and release the tension in the blade.
• Place the bore hole over the saw blade slot in the work bench.
• Install the saw blade through the hole in the work piece and through the
work blade slot, and fasten the blade to the holders.
• When you have completed the inside cut, remove the saw blade and then
remove the workpiece from the bench.
34
WARNING!
Switch off the saw and remove the mains
supply plug before installing saw blades in
order to avoid injuries caused by unintentio­
nal activation of the saw.
Working instructions