Operation - Dometic CI-21 Manuel D'installation Et D'utilisation

Induction Cooktop
q
e
4 Dimensions and Clearances for Placement
i
y
5 Cooktop Dimensions, Clearances, and Sealing Strip Instruction
Reference Dimension
30.0 in. (762 mm)
q
6.0 in. (152 mm)
w
14.2 in. (361 mm)
e
23.3 in. (592 mm)
r
1.2 in. (30 mm) x
t
20 in. (508 mm)
1.0 in. (25 mm)
y
8.0 in. (203 mm) x
u
1.0 in. (25 mm)
Place sealing strip around the cutout edge.
i
EN
t
w
r
u
u
Description
Minimum clearance
Minimum distance from
Cooktop to a surface
Cutout width
Cutout length
Back ventilation cutout
dimensions
Ensure minimum distance
from Cooktop to a wall or
cabinet
Front ventilation cutout
dimensions

5 Operation


WARNING: ELECTRICAL SHOCK, FIRE, AND/
OR BURN HAZARD . Failure to obey the
following warnings could result in death or
serious injury:
• Unplug the cooker from the outlet when not in use.
Allow it to cool before putting on or taking off parts.
• Do not operate any appliance with a damaged
cord or plug, or after the appliance malfunctions
or has been damaged in any manner. Return the
appliance to the nearest authorized service facility for
examination, repair, or adjustment.
• Do not let the cord hang over the edge of a table or
counter or touch hot surfaces.
• Do not use water on grease fires. Smother fire or
flame or use dry chemical or foam type extinguisher.
• Wear proper apparel. Loose-fitting or hanging
garments should never be work while using the
appliance.
• Do not operate this appliance by means of an
y
external timer or separate remote-control system.

WARNING: ELECTRICAL SHOCK HAZARD .
Failure to obey the following warnings could
result in death or serious injury:
• Shore power is the best option for the Dometic
Induction Cooktop.
• If a generator is used, it must have a pure sine wave
output and a minimum power rating of 2000 W.
• The Dometic Induction Cooktop should not be used
with inverting power supplies.

WARNING: FIRE AND/OR BURN HAZARD .
Failure to obey the following warnings could
result in death or serious injury:
• Flammable materials should not be stored near
surface units.
• Never leave surface units unattended at high heat
settings. Boil over causes smoking and greasy
spillovers that may ignite.
Operation
7