DeWalt D36000 Guide D'utilisation page 7

Fig. K
32
Adjustments
Cutting Wheel Square to Cart (Fig. L, M)
1. Open the cutting wheel cover using the cutting wheel cover knob
5
2. Place a 90 degree square on the cutting cart against the cutting wheel.
3. If the gap is not consistent, loosen the bevel lock knob
adjustment screw 44 with supplied wrench until the cutting wheel is 90° to the
cart surface.
4. Ensure that the cutting wheel does not touch either side of the groove in the cutting cart
by pushing the cart past the cutting wheel with saw turned off.
Fig. L
Fig. M
44
45
Cutting Wheel 45° to the Cart (Fig. M)
1. Loosen bevel locking knob and rotate the cutting head to 45°.
2. Put a 45° guide on the cutting cart surface next to the cutting wheel. If it is not at 45°,
adjust the 45° bevel adjustment screw
wheel is 45° to the cart surface.
3. With saw turned off, ensure that the cutting wheel does not touch either side of the
groove in the cutting cart by pushing the cart past the cutting wheel.
Cutting Parallel to Cutting Cart (Fig. N, O)
1. Lay a 90° square flat on the cutting cart surface with one end against the cart fence
Roll the cart forward so that the square is aligned to the cutting wheel, keeping the square
against the fence.
2. If the cutting wheel is not 90° to the cart fence, the rail will need adjustment.
3. Loosen the four rail assembly mounting screws
20
5
6
31
.
20
and adjust the 0° bevel
41
40
51
41
45 with the supplied wrench until the cutting
.
46
Fig. N
30
36
Fig. O
48
Cart Rolling Resistance (Rail Adjustment) (Fig. O)
1. Loosen the four rail height screws
2. Adjust the two rail height adjusters
3. Tighten the four screws.
Bevel Pointer (Fig. P)
Loosen the 0° bevel pointer screw
Fig. P
33
43
42
Depth of Cut (Fig. A, M)
1. Loosen head lock knob 4
2. Adjust depth of cut knob
cart surface.
3. With the unit turned off, push the cart past the cutting wheel and ensure that the cutting
wheel does not touch the cart.
4. Adjust the depth of cut knob and tighten the locking wing nut
knob 4 .
Cut Indicator (Fig. Q)
The cut indicator 39 assists in aligning long and diagonal cuts by showing where the cutting
wheel will exit the cut. The cut indicator can be used multiple times before adjustment
is necessary.
1. Loosen locking screw
50
2. Rotate cut indicator to expose uncut surface.
3. Tighten locking screw.
36 .
46
47
48 .
47 until cart moves smoothly.
and rotate the bevel pointer
43 42
.
40 until the cutting wheel is at least 3/16" (5 mm) below the
51 , then the head lock
.
English
46
to the correct location.
4
5