English
Fig. D
53
Fig. E
2
19
16
Attaching the Cutting Cart (Fig. F, G, Y)
1. Turn the cutting cart stop knob
18
into the unlock position (Refer to Cutting Cart Stop
Knob) and slide the cutting cart onto the rails.
2. Align the arrow on the rear of the cutting cart
the saw frame assembly
16
.
3. Slide the cutting cart assembly onto the rail system clearing the cutting cart stop knob
with the rollers.
4. Rotate the cutting cart stop knob into either the first or second posistion to keep the
cutting cart on the rails during use. Refer to Cutting Cart Stop Knob for description
of positions.
Fig. F
Fig. G
Attaching the Edge Guide (Fig. A, H)
1. Place edge guide
on the cutting cart assembly
19
2. Turn the edge guide lock
35
clockwise to tighten.
4
11
with the arrow on the rail on the left of
18
16
11
18
.
11
Fig. H
11
19
35
Assembling the Water Pump and Water Attachments
(Fig. A, I, J)
1. Place the threaded fitting
26
onto the water pump
to the threaded fitting (Fig. I).
nOTE: The ideal position for the water pump is in the front left corner of water pan, near
the drain plug.
2. Insert the pump power cord into the socket
protected receptacle.
3. Fill the pan with 5 gallons clean of water. The pump should be submerged.
nOTE: For longer pump life, always place the pump in a clean water source.
nOTE: The edge of the water pan
55
above the maximum water fill line.
4. Install the small rear water attachment
guard
10
if needed.
5. Install the small cutting cart water attachment
attachment
if needed.
13
Fig. I
28
26
Fig. J
29
Installing the Cutting Wheel (Fig. A, C, K, P)
1. Loosen (do not remove) the cutting wheel cover knob
cover
5
. Pull the rubber side flap back and lift the cover toward the rear of the saw.
2. Press spindle lock button
33
. Remove the cutting wheel nut
wrench
provided. Remove outer flange
25
3. Install the cutting wheel
6
against the inner flange
the same way as on the rotational arrow on the cutting wheel cover. Press the spindle lock
button
while tightening the cutting wheel nut.
33
4. Replace cover and tighten the cutting wheel cover knob
5. Adjust cutting wheel depth (Refer to Depth of Cut).
27
. Attach the clear water tube
(Fig. J) or plug it into a separate GFCI
29
is the maximum fill line. DO NOT fill the water pan
, large rear water attachment
, and splash
8
9
12
and large cutting cart water
on the side of the cutting wheel
20
30
with cutting wheel
.
31
32
with the rotational arrow facing
20
.
28
27
55