Wiring Diagram For Zone System - Last Calor TERMO-FLAVIA 30 Série Manuel D'installation

Connect one end of the power cable to the rear socket of the stove, and the other to the wall socket.
The voltage supplied by the system must match that specified on the stove dataplate and in the technical data
section of this manual.
During stove idle periods it is advisable to remove the power cable.
Make sure the electrical system is equipped with an earth and differential switch
in accordance with the current Regulations.
The power cable must never touch the stove exhaust pipe.
2.7 Wiring diagram

2.8 Wiring diagram for zone system

Before installing the heating stove in the house, check the type of heating system;
in case of several zones, a special electronic controller for multi-zone circuits, available as an optional, must be
installed. This is to prevent overheating of the heating chamber due to possible simultaneous closing of the zone
valves and consequent stopping of hot water flow.
45
T-FLAVIA30 **