Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
sigfox DRY CONTACTS - Guide utilisateur / User guide version V1.2.0
4.2.1 Product configuration request frame
This frame allows us to inform the product via the network that it must resend the product configuration uplink frame (0x10).
4.2.2
0
Code
0x01
4.2.3 Network configuration request frame
This frame allows us to inform the product via the network that it must resend the network configuration uplink frame (0x20).
0
EN
Code
0x02
4.2.4 Output control frame
This frame allows us to change the state of the TORs configured as outputs.
0
Code
0x03
0x03
Description of the frame:
•
Byte 1: States to be applied to the TORs
• Bit 0: State to be applied to TOR1
• Bit 1: State to be applied to TOR2
• Bit 2: State to be applied to TOR3
• Bit 3: State to be applied to TOR4
•
Bits 4 to 7: reserved
If the channel is configured as an output, the corresponding bit in the downlink frame 0x03 is taken into account, otherwise it is simply
ignored.
In the example in grey this gives:
Description of the frame:
•
Byte 1=0x05 i.e. 0101 in binary which gives:
• Bit 0=1 => TOR1 state set to 1 if TOR1 is configured as an output otherwise no change
• Bit 1=0 => TOR2 state set to 0 if TOR2 is configured as an output otherwise no change
• Bit 2=1 => TOR3 state set to 1 if TOR3 is configured as an output otherwise no change
• Bit 3=0 => TOR4 state set to 0 if TOR4 is configured as an output otherwise no change
•
Bits 4 to 7: reserved
1
2
X
X
1
2
X
X
1
2
Output
X
status
0x05
X
3
4
PAYLOAD
X
X
3
4
PAYLOAD
X
X
3
4
PAYLOAD
X
X
X
X
5
6
X
X
5
6
X
X
5
6
X
X
X
X
7
X
7
X
7
X
X
Page
68
of 80
Publicité
Table des Matières
